Installing The Device - Thermor ALLURE Manual De Instalación Y De Uso

The device you have just purchased was submitted to many tests and checks ensuring its quality.
We thank you for your choice and trust.We hope you will be fully satisfied.
A few recommendations:
Read the instructions before installing the device.
Power the device off before intervening on it, and check the power supply voltage.
Store the instructions, even after installing the device.
Characteristics of the device:
Cat C : Complies with EU standards for this category.
IP24 : Protected against water projections.
Classe II : Dual insulation.
1) Location of the device
- This device was designed to be installed in re-
sidential premises. In any other case, please call
your distributor.
- Installation must comply with the standards
currently enforced in the country of use.
- Locate the heater within minimum distances
from obstacles.
Do not install the device :
• In a draft likely to affect its control (under
centralised mechanical ventilation, etc...).
• Under a fixed mains outlet.
• Inside zones 0 and 1 in bathrooms.
The device is to be installed so that switches and other
controls cannot be touched by a person in the bath or sho-
wer, except in the UK where IEE Regulations 701.512.2 and
701.512.3 apply. These allow the use of IP24 rated products
and their integral controls in Zone 2 and ouside zones.
(shown on the machine's information label)
I
NSTALLING THE DEVICE
Volume
3
Volume
2
14
Volume
1
150 mm mini
150 mm mini
200 mm mini