Lenco HPW-400 Manual Del Usuario página 15

5.
OPERATION
In this description of the functions of the HPW-400 it's assumed
that the set is connected according to the instructions in chapter
4, that the battery is fully charged and that the base is connected
to a TV, radio or similar signal source.
5.1
To switch on the headset:
Use the ON/OFF switch on the side of the headset to switch the
headset on or off.
When switched on, the status LED will flash briefly while
the headset starts searching for the base.
Status LED:
flashing blue:
constant blue:
5.2
Volume and balance:
Use the volume control to adjust the sound volume
coming from the ear speakers.
Use the balance control to determine whether the left or
right ear speaker must be louder or softer than the other
ear speaker.
To prevent hearing damage we advise you to first
set the volume and then to put the headset on your
ears. This prevents a jolt if the volume was set too
high.
while searching for the base, the status
LED flashes in a blue color
as soon as the headset is connected to
the base, the blue status LED will remain
permanently lit
ATTENTION: when removing the headset from the base
while the ON/OFF switch is set to the ON position, you'll
have to first slide the switch to OFF and then back to ON.
15