Care And Cleaning; Storing The Water - Maytag SAV505DAWQ Guía Del Usario

Care and Cleaning

Turn off the water faucets after finishing the day's
washing. This will shut off the water supply to the
washer and prevent the unlikely possibility of damage
from escaping water.
Use a soft cloth to wipe up all detergent, bleach or other
spills as they occur.
Clean the following as recommended:
Control Panel – clean with a soft, damp cloth and glass
cleaner. Do not use abrasive powders or cleaning
pads.
Cabinet – clean with soap and water followed with an
appliance wax, if desired.
Lint Filter – it is self-cleaning and requires no mainte-
nance. The filter is located under the agitator on the
bottom of the washtub.
During the wash and
rinse portion of the
cycle, lint is collected on
the filter. Then during
the spin and drain the
filter is cleaned automat-
ically.
Storing the Washer
Washers can be damaged if water is not removed from
hoses and internal components before storage. Prepare
the washer for storage as follows:
• Select Regular, Light, and add one cup of chlorine
bleach OR white vinegar to a full load of water with-
out clothes. Run the washer through a complete
cycle. (Do not mix bleach and vinegar in the same
wash. Hazardous fumes can form.)
7
Interior – hard water deposits may be removed, if
needed, using a recommended cleaner labeled
washer safe.
The interior of the washer should be cleaned periodi-
cally to remove dirt, soil, odor or bacteria residue that
may remain in the washer as a result of washing
clothes. We recommend taking the following steps
every 60 to 120 days to clean and freshen your washer
interior. The frequency with which the washer should
be cleaned and freshened depends on factors such as
usage, the amount of dirt, soil or bacteria being run
through your washer, or the use of cold water.
To clean and freshen the washer interior:
1. Add a measured amount of chlorine bleach to the
bleach dispenser, following package directions.
2. Add 1/4 cup of detergent to the tub.
3. Run the washer through a complete cycle using
hot water.
4. Repeat the process if necessary.
• Turn the water faucets off and disconnect the inlet
hoses.
• Advance the cycle control knob to Spin and lower
the drain hose to eliminate any water that may be in
the drain hose.
• Disconnect the washer from the electrical supply and
leave the washer lid open to let air circulate inside
the tub.