Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Modifying the Heating Program
To change the heating program:
a. Press either of the PROGRAM
buttons to enter the programming mode.
The time / temperature settings for period
1 on Monday (DAY 1) will be flashing as
shown. The active period is highlighted by
a flashing square around the numbers at
the bottom of the screen and the selected
day is shown with the day indicator.
1
2
3
4
1
2
3
b. To adjust the period start time use
the
or
buttons, the 'OK?'
indicator will be displayed to confirm
the change. Holding the button down
will change the time quickly.
Note: If you are pressing the
or
buttons and the display flashes
the next period, it means the next
period will be pushed forward.
c. Once the required time is reached press
the green
button to confirm.
Note: If the original time setting did
not require adjustment press the green
button to move to step 'd'.
d. The temperature setting for period 1 on
Monday (DAY 1) will now be flashing.
To adjust this press the
buttons and confirm the setting again
by pressing the green
e. The next time and temperature period will
now be active. Adjust this by repeating
steps b - d above until all 4 periods are
set for Monday or press the AUTO button
to run the program as set, at any time.
You now have a choice of how to
set the program for the next day:
f. i) Press the COPY DAY button to copy
Monday's program into Tuesday. The
display will go blank apart from the 'non
14
or
5
6
7
4
or
button.
PROGRAMMING THE THERMOSTAT
flashing' day indicator, which indicates
the day copied and the 'flashing' target
day to copy the program to. To accept
this day press the green
select a different target day press the DAY
button until the 'flashing' day indicator
is under the required day, then accept
it by pressing the green
Note: Once the target day is confirmed
it becomes the day that is copied if the
COPY DAY button is pressed again.
OR
ii) Press the DAY button to move the
day indicator to Tuesday (DAY 2).
The program for that day can then
be adjusted by following steps b to
e. Programs for the remaining days
can be set in the same way, using the
DAY button to move to the next day.
To exit the programming mode select the
desired operating mode by pressing the
AUTO, MAN or OFF buttons. Note: To run the
adjusted program select the AUTO mode.
Disabling / Enabling Time Periods
The thermostat has 6 periods each day
that can be programmed, but you may
not need all of these switch points for
your heating requirements. Therefore, any
period from 2 to 4 can be removed from (or
returned to) the heating program profile.
To disable or enable time periods:
a. To disable unwanted periods go to the
desired period ( 2 to 4 ) using the
PROGRAM
or
ensure the correct period is highlighted
with the flashing square symbol. Press and
hold the
button for at least 2 seconds
and the display will indicate the period
has been removed from the program.
b. To enable periods again follow the same
procedure as above, navigating to the
already disabled period. To enable
this period again press and hold the
button for at least 2 seconds.
button. To
button.
buttons to navigate,
Publicidad
