Child Lock - Haier HW80-B1239N Manual De Usuario

3-Control panel
When the function is activated the temperature of the programme cannot be changed.
If "Temp." button is pushed the "Steam" function will be deactivated. You can activate
"Steam" function only before to start any programme. You cannot activate "Steam" func-
tion while the appliance is already executing a programme.
3-5-4
3-5-5
3-6
Note: Liquid detergent
If using liquid detergent, it is not recommended to activate the end time delay.
3-7
3-8-1
3-8-2
10
3.5.4 Function button"Extra rinse"
Press this button (Fig. 3-5-4) to rinse the laundry more
intense with fresh water. This is recommended for peo-
ple with sensitive skin.
By pressing the button several times one to three addi-
tional cycles can be selected. They appear in the display
with P--1/P--2/P--3.
3.5.5 Function "Speed up"
This function saves time and energy. Preferable if laun-
dry is slightly soiled. Press simultaneously button "Extra
rinse." and "Delay" (Fig. 3-5-5) for about 3 seconds to
activate the "Speed up" function;
This function is not available in all programmes (see
PROGRAMMES).
3.6 Function button "Delay"
Press this button (Fig. 3-6) to start the programme with
a delay. End time delay could be increased in steps of
means end of programme cycle will be in 6 hours and
30 minutes. Press "Start/Pause" button to activate the
time delay. It is not applicable to programme SPIN.
The default delay setting time is greater than the running
time of the program.
3.7 "Start/Pause" button
Press this button (Fig. 3-7) gently to start or interrupt
the currently displayed programme. During programme
setting and during programme run the LED above the
button is shining, or if interrupted blinking.

3.8 Child lock

Press button "Temp." and "Steam" (Fig. 3-8-1) for 3
seconds simultaneously to block all panel elements
against activation. For unlocking please press again the
two buttons.
The display shows
pressed, when the child lock is activated. The change is
not running.
is displayed.
(Fig. 3-8-2) if a button will be
EN