Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Procedure
Prepare Installation Space
Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection
strip between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
(40 mm).
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1
Make a mark exactly in the center of the cut-out.
Mount the long mounting rail to the front edge of
the cut-out and the short mounting rail to the rear
edge of the cut-out. The leading edges of the
mounting rails must lie upon the countertop. The
center marking of the mounting rails must
correspond precisely with the center marking of
the cut-out.
3
/
" (10 mm).
8
Take into
9
/
"
16
Note: For stone countertops, adhere the
mounting rails with temperature-resistant duel-
component adhesive (metal on stone).
2
For combination with the VD 201 device cover:
Mount device cover to device prior to installation
(see VD 201 Installation Instructions).
3
Insert device in cut-out. The snap-in pins on the
device must lie precisely on the clamp springs.
Press device firmly into the cut-out. The snap-in
pins on the device must snap into the clamp
springs.
Connect Electrical Supply
Refer to data plate for more information. See "Service"
for data plate location.
The branch-circuit breakers ampacity, the wire sizes
and the connections must be conform to the
requirements of the National Electrical Code or
Canadian Electrical Code and all local codes and
ordinances.
Attach flexible conduit to the junction box. Connect
the lead wires to the junction box supply wires in
proper phase:
▯
black (L1) to black
▯
red (L2) to red
▯
green to ground
5
Publicidad
Tabla de contenido
