Care & Cleaning; Cleaning Procedures - JENN-AIR JGC8645 Guía De Uso Y Cuidado

C & C
ARE

Cleaning Procedures

• Be sure appliance is off and all parts are cool before handling
or cleaning. This is to avoid damage and possible burns.
• To prevent staining or discoloration, clean appliance after each use.
• If a part is removed, be sure it is correctly replaced.
PART PROCEDURE
Burner Heads • The surface burner heads are removable. The cap portion of the head is
porcelain and the port area is aluminum. Wash the burner heads in the
sink with mild detergent and a plastic scrubber.
• Check to be sure all ports are open. To open clogged ports, insert a
straight pin directly into each port. Do not enlarge or distort the port.
• When replacing the burner heads, carefully align the tabs on the burner
base with the indentations in the head. The three pins will fit in the slots
NOTE: When burner heads are removed for cleaning, do not spill liquids
through the holes in the burner base.
Burner Grates • Wash with warm, soapy water and a nonabrasive, plastic scrubbing pad. For stubborn soils,
clean with a soap-filled, nonabrasive pad or a sponge and Cooktop Cleaning Creme (Part
#20000001)** and sponge. If soil remains, reapply Cooktop Cleaning Creme, cover with a damp paper
towel and soak for 30 minutes. Scrub again, rinse and dry.
• The grates are made of porcelain on cast iron and are very durable, however, they will gradually lose
their shine and/or discolor. This is due to exposure to high temperatures from the gas flame.
• Do not clean in dishwasher or self-cleaning oven.
Control Knobs • Remove knobs in the OFF position by pulling up.
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
• Turn on each burner to be sure the knobs have been correctly replaced.
Cooktop- Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid proof.
Porcelain Enamel All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.
• When cool, wash with soapy water, rinse and dry.
• Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.
• Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.
Cooktop- • DO NOT USE ANY CLEANING PRODUCT CONTAINING CHLORINE BLEACH.
Stainless Steel • ALWAYS WIPE WITH THE GRAIN WHEN CLEANING.
(select models) • DO NOT USE ORANGE OR ABRASIVE CLEANERS.
• Daily Cleaning/Light Soil –– Wipe with one of the following - soapy water, white vinegar/water
solution, Formula 409 Glass and Surface Cleaner* or a similar glass cleaner - using a sponge or soft
cloth. Rinse and dry. To polish and help prevent fingerprints, follow with Stainless Steel Magic Spray*
(Jenn-Air Model A912, Part No. 20000008)**.
• Moderate/Heavy Soil –– Wipe with one of the following - Bon Ami, Smart Cleanser, or Soft Scrub*
- using a damp sponge or soft cloth. Rinse and dry. Stubborn soils may be removed with a damp
multi-purpose Scotch-Brite* pad; rub evenly with the grain. Rinse and dry. To restore luster and
remove streaks, follow with Stainless Steel Magic Spray*.
• Discoloration –– Using a damp sponge or soft cloth, wipe with Cameo Stainless Steel Cleaner*.
Rinse immediately and dry. To remove streaks and restore luster, follow with Stainless Steel Magic
Spray*.
* Brand names for cleaning products are registered trademarks of the respective manufacturers.
** To order direct, call 1-800-JENNAIR (1-800-536-6247).
LEANING
CAUTION
when the tab is aligned with the indentation.
7
BURNER HEAD
Cap
Ports
Port Area
Indentation
Slots Align
with Pins
Ignitor
Tab
BURNER BASE