Tabla de contenido
Publicidad
SWZV STEERING CONTROLS
STEERING TO THE LEFT TRAVELING FORWARD
STEERING TO THE RIGHT TRAVELING IN REVERSE
STEERING TO THE RIGHT TRAVELING FORWARD
STEERING TO THE LEFT TRAVELING IN REVERSE
Figure 4-3 Steering Controls
4.6 ENGAGING THE DECK DRIVE (CUTTER
BLADES)
1. Set the throttle at about 3/4 speed. Do not attempt to
engage the deck drive at high speed as this shortens
the electric clutch life — use only moderate engine
speed when engaging the deck drive.
2. Engage the deck drive by pulling out on the yellow
switch, located on the instrument panel, (Figure 4-4)
to the engage position.
Figure 4-4 Cutter Engage Switch
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
STT99CES
CAUTION:
Disengage power to the mower before backing
up. Do not mow in reverse unless absolutely
necessary and then only after observation of the
entire area behind the mower.
CAUTION:
Before backing up, observe behind the mower for
persons and obstructions. Clear the area before
backing up. Possible injury or property damage
could occur.
A squealing noise may be heard when engaging
or disengaging the deck drive. It is caused by
the electric clutch plates meshing as the mower
comes up to speed. This is normal.
3. To disengage the deck drive, push the switch in to the
disengage position.
4. Always operate the engine at full throttle to properly
maintain cutting speed. If the engine starts to lug
down, reduce the forward speed and allow the
engine to operate at maximum RPM.
14
Section 4
-NOTE-
Publicidad
Tabla de contenido
