Scag Power Equipment SWZV Manual Del Operador página 29

Section 6
3-Position Custom-Cut Baffle Adjustment
A. 3" Position - (See Figure 6-9, Page 26).
For very tall, wiry, tough to cut grass.
B. 3-1/2" Position - (See Figure 6-9, Pagee 26).
For general purpose cutting. Placing the Custom-Cut
Baffle in the 3-1/2" position gives a good mix of
cutting performance in all types of grass.
C. 4" Position (factory setting) - (See Figure 6-9, Page
26).
Placing the baffle in the 4" setting will enhance fall
cutting (leaf pickup).
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck.
-NOTE-
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6-9, Page 26).
4. Reinstall the mounting hardware. Torque hardware
to 39 ft-lbs
7-Position Custom-Cut Baffle Adjustment
A. 3-1/2" or 3-3/4" Position - (See Figure 6-10, Page 26).
For very tall, wiry or tough-to-cut grass.
B. 4" (factory setting), 4-1/4" or 4-1/2" Position - (See
Figure 6-10, Page 26).
For general purpose cutting. This gives the best mix
of cutting performance in all types of grass.
C. 4-3/4" or 5-1/4" Position - (See Figure 6-10, Page 26).
Placing the baffle in either the 4-3/4" or 5-1/4" setting
will enhance fall cutting (leaf pickup) and reduce
cutter deck "blowout".
To adjust the Custom-Cut Baffle height:
1. Place the cutter deck in the transport position.
2. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck.
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on cutter deck size.
3. Move the Custom-Cut Baffle to desired position.
(See Figures 6-10, Page 29).
4. Reinstall the mounting hardware. Torque hardware
to 39 ft-lbs
25
-NOTE-