Configuration; Main Menu - Vimar 20511 Manual De Instrucciones

Configuration - Main menù

6. CONFIGURATION.

The touch screen is configured by means of EasyTool Professional LT software and the programming interface
01998.U; by means of the database downloaded from the By-me control panel with which the system was confi-
gured, you can then select the functions (groups, scenarios, etc.) that you want to control with the touch screen.
For all details see section 2.3 of the EasyTool Professional LT software manual.
At the end of programming with the EasyTool Professional LT, it is necessary toconfigure the touch screen in the
By-me system so that the device is recognised by the control panel and can interact with the system; the device
is configured as follows:
- if you want to display and control the burglar alarm system, the touch screen must be configured in a zone of the
burglar alarm system (Setup --> Configuration--> Group Management -->Burglar alarm --> Select group/zone)
- if you do not want to display and control the burglar alarm system, it is sufficient to configure the touch screen in
any of the Automation Groups (Setup --> Configuration --> Group Management-->Automations)
To start configuring the touch screen from the main menu, touch these icons in the following order:
  
WARNING: Once you have downloaded the touch screen shots with EasyTool Professional LT and have con-
figured it on By-me control unit, you will then need to synchronise the touch screen router by touching the
then the (see page 27 of this manual).

7. MAIN MENU.

Once the touch screen has been configured with EasyTool Professional LT, the opening screen is displayed contai-
ning the various sections for the control/command of the whole system. Touching the icon gives
access to the Settings menu.
25