Ef-6000 Transmitter; Ef-6000 Receiver Collar - Dogtek EF-6000 Guia De Instalacion

7

ef-6000 TRaNsmITTeR

Diagram 2
EF-6000 Transmitter
Warning area
adjustment buttons
Stimulation area
adjustment button
Small or large ground
selector
warning area indicator
Simulation area indicartor
Broken boundary wire or
connection default indicator
power on/off the transmitter
• Power On: connect the transmitter to the power supply by plugging the AC adapter into the power jack
on the transmitter and into a wall outlet.
Indications appear on the LCD screen, the transmitter is On.
• Power Off: disconnect the AC adapter from the wall outlet.
The LCD screen goes out, the transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the
antenna socket. The wire break alarm would alert you to a connexion default (ref. § Safety features).
When you disconnect the transmitter, the boundary settings are memorized. Next time you will power on
the transmitter, the settings will be the last selected.
LCD screen
Power jack
Boundary socket with
transmitter connector
Diagram 3
LCD SCREEN
Small / large ground
indicator

ef-6000 ReCeIveR COllaR

Contact points
(short or long)
Area where the green indicator
Battery charge level indicattor
Area where the magnetic switch is located
This magnetic switch allows you to turn ON/OFF the
collar and to select the simulation level (modes)
Charging the collar
To charge your collar, proceed in the following way:
• connect the charger to a wall outlet
• connect the power cord to the collar (after a few seconds, the green indicator light starts blinking every
5 seconds)
• when the battery is fully charged, the green indicator light goes out
• disconnect the charger from the collar and put the protection tab back in place
• disconnect the charger from the wall outlet
We advise you to fully charge the battery before the first use.
A full charge takes approximately 3 hours.
power on/off the collar
The supplied magnetic key allows you to turn on/off the collar.
• Power On: move the magnetic key towards the collar
so that it comes into contact with the area where the
magnetic switch is located (ref. Diagram 5).
The collar will emit 2 beep sounds and the green indicator
light will flash every 5 seconds indicating that the collar
is On.
• Power Off: move the magnetic key towards the collar
so that it comes into contact with the area where the
magnetic switch is located (ref. Diagram 5).
The collar will emit 1 beep sound and the indicator light
goes from flashing to permanent green then goes out
indicating the collar is Off.
To increase the battery life, we recommend you to turn off the collar if you are not using it for a long period.
If your dog needs to leave the authorized area, you have to remove the collar or power off the transmitter
by disconnecting it from the power supply.
Diagram 4
EF-6000 collar
light is located:
ON/OFF indicator
+
Charging jack
protection tab
Magnetic key
(magnet)
Diagram 5
Activate / deactivate
the EF-6000 collar with the
magnetic key
www.dogtek.com
8