Introduction; Safety; Safety And Responsibility; Installation - SOMFY Lighting Modulis Ramp RTS Manual De Instrucciones

Installation guide
1. Introduction
2. Safety
2.1 Safety and responsibility
3. Installation
3.1 Contents of the kit
3.2 Equipment required
3.3 Installation recommendations
3.4 Safety distances
3.5 Fitting the Lighting Modulis RTS Ramp
4. Wiring
5. Commissioning
5.1 Programming an RTS control point
6. Operation
6.1 With an RTS control point from the Modulis
range
6.2 With an RTS control point

1. Introduction

The Lighting Modulis RTS Ramp is a lighting ramp equipped with:
- pivoting mountings and halogen spots to direct light to the required area.
- Radio Technology Somfy (RTS) to allow remote use and the creation of personalised
environments.
The Lighting Modulis RTS Ramp operates with a maximum power of 100 W with a 230 V supply
and is operated from an RTS control point. The Lighting Modulis RTS Ramp enables the intensity of
the lighting to be varied as well as the preferred light intensity to be programmed, i.e. the favourite
position: By default, the favourite light intensity factory setting is 50% of the maximum intensity.
The Lighting Modulis RTS Ramp is used:
- as an individual control - one Lighting Modulis RTS Ramp is controlled by one control point,
- as a multiple control - one Lighting Modulis Ramp is controlled by several control points (maximum
of 12 control points),
- as a group control - several Lighting Modulis RTS Ramp units are controlled from a single control
point.

2. Safety

2.1 Safety and responsibility

Before installing and using this product, please read the installation guide carefully.
Moreover, the installer must comply with current standards and legislation in the country in which the
product is being installed, and inform his customers of the operating and maintenance conditions for
the product.
Any usage outside of applications defined by Somfy constitutes non-compliance, and is therefore not
covered by the guarantee. In this event, as for all usage not consistent with the instructions given
here, Somfy declines any responsibility for harm or damage.
Never begin installing without first checking the compatibility of this product with the associated
equipment and accessories.
Never look directly at the lamps at close range when the ramp is on

3. Installation

3.1 Contents of the kit

a. Lighting Modulis RTS Ramp
b. Support base x 3
c. pivoting mounting x 3
d. "T" bracket x 3
Copyright © 2009 Somfy SAS. All rights reserved.
5061612X00_LMR_RTS_livre.indb 33
Contents
33 7. Optional additional settings
7.1 Adding/Deleting RTS control points
33
7.2 Creating multiple or group controls
33
7.3 Setting the "my" favourite light intensity
33
8. Tips and recommendations
33
8.1 Problems with the Lighting Modulis RTS
34
Ramp?
34
8.2 Replacing a lost or broken control point
34
8.3 Restoring the original configuration
34
8.4 Replacing a lamp
35
9. Technical data
35
35
36
36
36
e. Allen keys BTR x 6
f. Plugs x 3
g. Screws x 3
h. Headless screws x 6
i. Plastic cover
Lighting Modulis RTS Ramp
37
37
37
38
39
39
39
39
40
40
a
b e h
c f i
d g
33
30/04/09 18:44:47