Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE YOU BEGIN
Description
These Campbell Hausfeld wire feed welders are designed to be used on standard 120V outlets. The welder is
equipped with infinite wire speed control to accurately select the proper wire feed rate needed for various
welding conditions. Internal components are thermostatically protected.
The DW3130 is designed for use with the Flux Cored Arc Welding (FCAW) or the Gas Metal Arc Welding
(GMAW) process. As delivered from the factory, this welder can weld with .030 inch (0.8 mm) diameter flux
core wire. A starter spool of .030 inch (0.8 mm) flux cored wire is included.
To use the GMAW process with the DW3130, it is necessary to purchase shielding gas and MIG wire only.
UNPACKING
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for
loose, missing or damaged parts. Check to be sure all supplied accessories are enclosed with the unit. In case
of questions, damaged or missing parts, please visit www.campbellhausfeld.com for customer assistance.
Required Items - Not Included
•
Gas Hose - 100 cm
•
Flux Core Wire 0.8 mm, 0.2 kg Spool
•
Contact Tip 0.024 inch (0.6 mm)
•
Contact Tip 0.035 inch (0.9 mm)
GENERAL SAFETY INSTRUCTIONS
Safety Guidelines
This manual contains information that is very important to know and understand. This information is
provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe
the following symbols.
IMPORTANT or NOTE: Information that requires special attention.
Safety Symbols
The following Safety Symbols appear throughout this manual to alert you to important safety hazards and
precautions.
Risk of
Read
Fire
Manual
First
Risk of
Wear eye
Magnetism
protection
Do not operate unit if damaged during shipping, handling or use. Damage may result in
bursting and cause injury or property damage.
Danger indicates an imminently hazardous situation which, if not avoided, WILL result in death
or serious injury.
Warning indicates a potentially hazardous situation which, if not avoided, COULD result in
death or serious injury.
Caution indicates a potentially hazardous situation which, if not avoided, MAY result in minor or
moderate injury.
Notice indicates important information, that if not followed, may cause damage to equipment.
MANUAL
Risk of
Risk of Shock
Flying
Fragments
•
Hose Clamp
•
Hex Wrench
•
Contact Tip 0.030 inch (0.8 mm)
•
Gas Regulator
Risk of
Risk of
Light Rays
Hot Parts
1
Risk of
Risk of
Explosion
Fumes
Publicidad
Tabla de contenido
