Publicidad
Idiomas disponibles
Idiomas disponibles
English
Defect
Indicator
no.
E01
E11
E16
E30
E42
E44
E47
E50
E53
E54
E60
E71
10.1 Defect acknowledgement
CAUTION! Possible damages!
Cancel defects only when their causes have been
removed.
• Only authorized service representative are
allowed to remove defects .
• Defect acknwoledgement could be done:
22
Delay time
Delay time
before auto-
before defect
matic restart
activation
(if any)
60s
60s
5s
60s
60s
No restart
60s
300s
5s
No restart
5s
No restart
5s
No restart
15s
60s
< 1s
No restart
Maximum
defect
Defects / causes
number
per 24h
Pump speed is too low
Pump is faulty
6
Defective pump shaft
coupling
Wrong threshold for low
speed parameter
Air-binding or dry running
6
of the pump
Wrong direction
1
of rotation
Ambient temperature is
6
too high
Pressure sensor wire is cut
1
(4-20mA)
Speed sensor wire is cut
1
(4-20mA)
X-Care temperature sen-
1
sor is damaged
CAN bus failure
Duplicated CAN address
CAN bus disconnected
Total pump head is too
high for the pump
6
Wrong threshold for maxi-
mum head parameter
1
EEPROM failure
- Either by infrared communication in
Service/Error menu.
- Or by CAN bus (20C0h parameter)
- Or by switching X-Care off.
If the fault cannot be solved, please contact
Salmson customer services.
Remedies
Fluid viscosity is too high
Dismantle the pump, clean and change
defective parts
Check torque for coupling screws
Modify low speed parameter
Prime the pump again (refer to installa-
tion and operating instructions manual
provided with the pump)
Check tightness of seals and gaskets on
suction side
Invert 2 phase wires for pump power
supply
X-Care is specified not to work for an
internal ambient temperature greater
than +70°C
Check fluid temperature that must not
be above 120°C
Check sensor wire
Check sensor wire
Call customer services
Check connections
Check all the devices connected to the
CAN bus have all different addresses
Check CAN network
Use a pressure reducing valve at suction
to limit maximum head
Modify maximum head parameter
Call customer services
SALMSON 12/2013
Publicidad
