Milwaukee M18 HCC75R Manual Original página 10

The operator of the remote control must select a location from
which the danger zone can be seen to ensure at all times that no
one is in the sealed danger zone.
Do not expose tools to rain. Do not use tools in damp or wet
locations.
Preparation of cable cutter and battery
Before every use:
• Inspect cable cutter for external defects
• Check the cutting tool for cracks and other signs of wear
Only use in perfect condition!
USE
WARNING : To reduce the risk of explosions, electric shock and damage to property and equipment, never cut live
electrical cables.
Tool is NOT insulated. Contact with a live circuit could result in severe injury or death. Turn o power before making a
cut. Never cut gas or water lines. Keep hands away from all cutting edges and moving parts. Laceration and amputation
can occur.
Always remove battery pack before changing or removing accessories. Only use accessories speci cally recommended for
GB
this tool. Others may be hazardous.
To reduce the risk of injury, wear safety goggles or glasses with side shields.
WARNING : To reduce the risk of injury, only cut recommended materials for the blades. (see „Speci cations") Do not
attempt to cut other materials.
To stand the tool up on the ground, turn the cutting head 180° so
the front hand grip can be used as a base.
To hang the tool, use the front handle and tool hanger to set the
tool in a hanging position.
English Deutsch
8
Before the remote cutting process begins, the battery capacity
must be checked: minimum 33% (see illustrated description).
It may require charging before work commences.
Preparation for the cutting process (with and without
remote control)
Support and x the cable to be cut in order to minimize the risk of
uncontrolled movement.
Overhead cables, in particular, can move out of control and cause
injury and/or damage.
> 340°