Philips pronto RFX9600 Manual De Inicio página 13

2
Make sure that the PC is switched to DHCP while the Extender is in configuration
(normally, this should already be the case).
3
Set the Configuration switch to 2 for configuration:
The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
4
Open the browser.
5
Type the IP address of the Extender in the address bar of the browser: 192.168.8.80.
(This is also printed on the back of the Extender.)
You may have to refresh the browser before the Configuration Tool appears.
6
Make sure you have the IP address and netmask at hand, and follow the onscreen
instructions.
7
When the configuration is completed, disconnect the Extender from the computer and
reconnect it to the router with a straight Ethernet cable. Set the Configuration switch
to 1 for use.
Configuration through a router
1
The Extender is already
connected to the router.
Connect the router to the PC
as well.
2
Set the Configuration switch to 3 for configuration:
The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
3
Open ProntoEdit Professional on the PC.
4
In the Tools menu, select Extender Discovery.
The Extender Discovery tool appears, with a list of all the detected Extenders in the Pronto
Network.
Configuration switch: 2
Extender
Router
Configuration switch: 3
RFX9600 Starter's Guide
Straight
Ethernet cable
10