Scope Of Supply; General Instructions - Kathrein EXI 01 Guia De Inicio Rapido

Modem
IP over coax
Features
Modem for the Kathrein IP over coax system "K-LAN"

(based on the IEEE 1901 standard)
Creation of a home network over the existing terrestrial

coax distribution for the satellite system.
This reduces the cost of installation - no new network
cables need be laid
Ideal for the network connection of receivers, TV sets

and Blu-ray players. In addition, a PC and other
network-capable devices can easily be connected
via a router (such as Fritzbox)
> 500-Mbit data throughput (gross) is suffi cient

for several HD streams plus data transmission
between PCs. QoS * allows prioritisation of the
)
respective services
Integral highly selective diplexer - no interference

between FM, TV and satellite signals.
No additional splitters are necessary
High screening factor prevents interference

1 input (IP & Sat/TV/FM); 1 output (1 x Sat/TV/FM);

1 x Ethernet RJ45. DC is looped through
128-bit AES encryption. Secure private network

connection at the push or a button - no software
required
In conjunction with the optimised EXI 3508 distribution

system, distances of > 700 m are achievable in the
IP frequency range
The modem can be remotely fed by the connected

satellite receiver, using the port on the EXI 30 outlet.
In all other cases the power is supplied by the plug-in
power supply unit. The EXI 30 outlet has been specially
developed for the K-LAN **
Eco Power Mode: The modem automatically switches

to stand-by until it is "woken up" again by the network.
Consumption: 0.5 Watt in stand-by/max. 4.2 Watt in
operation

* Quality of Service
)
** Alternatively the ESD 84 and ESD 32 outlets can also be used
)
)

Scope of supply

EXI 01

Energy-effi cient plug-in power supply unit for power

supply, e.g. for operation at a PC
Screened network cable 1.5 m Cat 6A

Accessories
High-pass fi lter EXI 90 BN (20510062): If the EXI 01 is

operated via a multi-switch not from the EXI range the
high-pass fi lter must be screwed on to the terrestrial
input of the multi-switch. This isolates the downstream
multi-switch and prevents reception and emission in the
IP frequency range by and from the terrestrial antenna
Software EXI 700: Displays the visible modems on a

network (download from: www.kathrein.de)
EXI 30 (article no.: 21110024): Outlet remotely fed from

the SAT port, with optimum selection for data and RF
signals

General instructions

If a switchable LNB such as UAS 585 is used, or a

multi-switch with a power consumption of more than
50 mA per connection, the modem must be powered
using the power supply unit included
If the modem is driven from a PC or the like, an

EMK 03 terminating resistor should be screwed to
the unused output
1 / 8
20510061
EXI 01