Joovy CocoonX2 Manual Del Usario página 5

Assembling and Using the Fixed Front Wheel Attachment
The fixed front wheel attachment is sold separately. To ensure safe operation of your jogging stroller, please follow these instructions
carefully.
11 Installing the Fixed Front Wheel
• Tilt the stroller so it is resting on the handlebar and the rear wheels.
• Remove the front swivel wheels by pressing the release button located on the back of the front wheel housing and pulling the wheel away
from the stroller. Repeat for the other side.
• Remove the locking pin from the attachment housing (located on the lower front end of the stroller) by pulling the safety clamp over the pin
and sliding the pin out. See Figure 11.1.
• Insert the front wheel tube into the housing at the center front of the stroller, with the wheel pointing forward. Line up the holes on the
sides. See Figure 11.2.
• Insert the locking pin through the holes and attach the safety clamp over the pin to ensure it is secure. See Figure 11.3.
• Pull the wheel away from the stroller to ensure it is securely installed.
• To remove this accessory, reverse the instructions in this section.
12 Wrist Tether Strap
There is a tether strap located on the rear frame of the stroller to keep your stroller close by if you lose your grip.
• Always loop the wrist tether around your wrist before using your stroller.
Jogging Stroller Mode (Optional)
WARNING
!
Use caution not to get pinched by the locking clamp.
EN FR ES