Shelf Instructions; Moving And Vacations - Danby Designer DWC110BLSRH Manual Del Usario

Shelf Instructions

I M P O R TA N T !
Do not cover shelves with
aluminum foil or any other
material that will prevent
adequate air circulation
within the cabinet.
Moving &
Vacations
Operating Instructions
To remove a roller-shelf
(Fig.E) :
1. Gently slide the shelf outward
until it meets resistance.
2. Tilt the shelf slightly upwards
(approximately 15°) and
carefully remove the shelf by
sliding it outward from the
cabinet.
Fig. E
To reinstall a roller-shelf:
1. Set the shelf's wheels upon
the front of the wheel track.
2. Tilt the front of the shelf
slightly upwards (approxi-
mately 15°), and begin to
gently slide the shelf into the
cabinet until the shelf's roller-
wheels slide naturally within
the wheel track.
If you move
1. Remove or securely
fasten down all loose
items inside the wine
cooler.
2. To avoid damaging the
leveling screws, turn
them all the way into the
base.
9
To remove the bottom two
shelves:
1. Grasp the top, wooden area
of the shelf with your hand.
2. While grasping the shelf,
gently apply upward
pressure to the back of the
shelf and downward
pressure to the front of the
shelf.
3. Begin to slowly pull the shelf
15°
2
outward until it unhooks
from the stoppers, and then
remove the shelf from the
cabinet.
1
To reinstall the bottom two
shelves (Fig. F):
1. Slide the shelf beneath the
track that is directly above
the track you want the shelf
to rest on.
2. Once the back-end of the
shelf is in contact with the
back wall of the cabinet,
lower the shelf onto the
track.
Fig. F
Vacation Time
For short vacation periods,
leave the controls at their
usual settings. During longer
absences;
1. Remove all bottles.
2. Disconnect from
electrical outlet.
3. Clean the wine cooler
thoroughly.
4. Leave the door open to
avoid formations of
condensate, mold or
odors.
1
2