How To Stop Your Pressure Washer; Cleaning And Applying Detergent - Snapper 580.752640 Manual Del Operador

How to Stop Your Pressure Washer

1. Release spray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOP position.
WARNING: Backfire, fire or engine damage could
occur.
• DO NOT stop engine by moving choke control to "Choke"
position ( ).
3. ALWAYS point spray gun in a safe direction, press red
button and squeeze spray gun trigger to release retained
high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING: The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger to release high pressure, every
time you stop engine.
How to Use PrecisionSpray™ Selector
Refer to the PrecisionSpray™ Selector instruction sheet for
proper use.
NOTICE: Product damage will occur if the gun trigger is
squeezed while the Selector is in-between nozzle settings.
• NEVER turn the Selector while spraying.

Cleaning and Applying Detergent

CAUTION: Chemicals can cause bodily injury, and/or
property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent follow these steps:
1. Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
NOTICE: Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle, route
the tube so as to keep it from inadvertently contacting the hot
muffler.
2. Prepare detergent solution as required by job.
3. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
4. If using cleaning tank, pour detergent into cleaning tank.
NOTE: The cleaning tank holds two gallons.
NOTICE: Cleaning tank damage may occur if not drained
prior to removing handle.
5. Rotate PrecisionSpray™ Selector to a low pressure
position, as described in the PrecisionSpray™ Selector
instuction sheet.
NOTE: Detergent cannot be applied with the PrecisionSpray™
Selector in a high pressure position.
6. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump. Turn on water.
NOTICE: You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7. Start engine following instructions How to Start Your
Pressure Washer.
13