Checklist Before Starting Engine - Snapper 580.752640 Manual Del Operador

3. Before connecting garden hose to water inlet, inspect
inlet screen. Clean screen (A) if it contains debris or have
it replaced if damaged. DO NOT run pressure washer if
inlet screen is damaged or missing.
4. Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE: Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connector
damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
A
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
6.

Checklist Before Starting Engine

Review the unit to ensure you have performed all of the
following:
1.
2.
3.
4.
5.
6.
10
WARNING: Risk of eye injury.
Spray can splash back or propel objects.
Turn ON the water, press red button (B) on the gun and
squeeze the trigger to purge the pump system of air and
impurities.
Be sure to read Safety Rules and Operation sections
before using the pressure washer.
Make sure handle is in place and secure.
Check that oil has been added to proper level in engine
crankcase.
Add proper fuel to fuel tank.
Check for proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damage to the high pressure hose.
Provide proper water supply (not to exceed 100°F).
B