Duty Cycle - Porter Cable C6001 Manual De Instrucciones

Model No.
Running Horsepower
Bore
Stroke
Voltage/Hz-Single Phase
Minimum Branch Circuit Requirement
Branch Circuit Fuse Type
Air Tank Capacity
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psig
SCFM @ 90 psig
Regulated Pressure Rating (Approximate) 3–150 psi
Quick Connect Type
*Tested per ISO 1217
Refer to Glossary for abbreviations.
Become familiar with these terms before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of measure of pressure.
Code Certification: Products that bear one or more of the following marks: UL
®
CUL, CULUS, ETL , CETL, CETLUS, have been evaluated by OSHA certified
independent safety laboratories and meet the applicable Standards for Safety.
Cut-In Pressure: While the motor is off, air tank pressure drops as you continue
to use your accessory. When the tank pressure drops to a certain lower level the
motor will restart automatically. The low pressure at which the motor automatically
restarts is called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is turned on and begins to run, air
pressure in the air tank begins to build. It builds to a certain high pressure before
the motor automatically shuts off, protecting your air tank from pressure higher
than its capacity. The high pressure at which the motor shuts off is called "cut-out"
pressure.
Branch Circuit: Circuit carrying electricity from electrical panel to outlet.
This air compressor pump is capable of running continuously. However, to
prolong the life of your air compressor, it is recommended that a 50%-75%
average duty cycle be maintained; that is, the air compressor pump should not
run more than 30-45 minutes in any given hour.
Accessories for this unit are available at the store the unit was purchased.
The use of any other accessory not recommended for use with
this tool could be hazardous. Use only accessories rated equal to or higher
than the rating of the air compressor.
SPECIFICATIONS
C6001
1.1 *
1.875" (47.6 mm)
1.250" (31.8 mm)
120/60
15 amps
Time Delay
17 Gallon (64.4 liters)
120 psig
150 psig
4.3 *
3.3 *
1/4" (6.4 mm) Industrial
GLOSSARY

DUTY CYCLE

ACCESSORIES
8 - ENG
® ,