Assembly - Workzone 47625-15 Manual Del Usuario

Dual halogen worklight with stand
ASSEMBLY INSTRUCTIONS
Although your Dual Halogen Worklight comes mostly assembled, you must
assemble the dual lamp head. Attach the assembly to the tripod and install a
halogen bulb into each lamp head.
WARNING: Risk of electrocution and severe burns. Do not plug in the
worklight before completing assembly. Never operate the light with the
wire lens guards off and the halogen bulb exposed.
Portable Dual Lamp Head Assembly
1) Locate the portable stand. Place the portable stand on a flat surface.
2) Attach the lamp heads to the portable stand with the two twist knobs, two screws
and two washers. Lamp heads should face the front. Each lamp head has an
attached U-shaped bracket with a hole that lines up with the holes on the portable
stand. Insert a machine screw through the bottom of the portable stand. Place a
washer over the screw then place the U-shaped bracket over washer. Thread on
plastic knob and tighten. See Fig. 2.
3) Attach wire lens guard to the front of the light.
6
service@eurocentra.net
MODEL: 47625-15 PRODUCT CODE: 47625
Fig. 2
AFTER SALES SUPPORT
05/2015

Assembly

1 866 558 8096