Installation - Omcan RS-CN-0004-P Manual De Instrucciones

this distance if the obstacle is a heat source.
3. Level the appliance by adjusting the screw feet. It should be placed on the level solid surface to reduce the
vibration and noise.
4. The ambient temperature must be between 10-32°C/50-89.6°F (Climatic Class 4). Avoid locating it in direct
sunlight or near heat source such as an oven or a radiator.
5. Please make sure the appliance is properly ventilated.
6. Power supply and voltage at the operating point that complies with the details on the rating label. The plug
must be accessible after installation.
7. Correctly connect and disconnect the plug. When insert the plug, it must be plugged tightly when pulling
out the plug, the plug should be held by hand. Never pull the supply cord directly.
8. If the showcase is to be shut down for long period, switch it off and disconnect the plug from socket outlet.
Clean the appliance and leave the lid open to prevent odor.
9. Important! For your personal safety, this appliance must be properly grounded. This appliance is equipped
with a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that is
properly grounded and installed. Consult a qualified electrician or service center if you do not completely
understand the grounding instructions. If doubt exits as to whether the appliance is properly grounded,
have a qualified electrician check the circuit to make sure the outlet is properly grounded.
10. If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified
electrician to fix a new socket. Do not use an extension cord.
11. If power is cut off, wait for at least 3 minutes before restart the unit to avoid damaging the compressor.
INSTALLATION OF FIT GLASS PANELS
ATTENTION: RISK OF BREAK WITH THE GLASS PANEL.
Note: Ensure the hole in the collar for the grub screw faces inwards.
Note: Ensure the screw hole furthest from the edge of the panel goes to the back of the appliance.
Note: Ensure the soft end of the grub screw is the end making contact with the glass.
Note: Ensure the short end of the bolt assembly is on the outside of the panels.
Note: The glass panel must not be used as shelf.
1. Unpack the wooden/carton box carefully; it's recommended to do this work with two people.
2. Screw the collars to the rim of the appliance.
3. Slot the two side panels into the collars, with the holes in the glass at the top.
4. Screw a grub screw into each collar to secure the panels.
5. Slot the rear panel into the collars, with the holes in the glass at the top.
6. Screw a grub screw into each collar to secure the panel.
7. Slot the plastic bushes into each of the holes.
8. Screw the brackets to the inside of each panel using the bolt assemblies.
9. Place the top panel onto the brackets, ensuring all holes line up.
10. Insert the bush and attach the top panel to the brackets with the bolt assemblies.
7

Installation