ACD MFT10 Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Only original ACD power packs or the ACD power supply cable
may be used for operating the MFT10. Please observe the input
voltage range on the rating plate located at the rear of the device.
ATTENTION
Tampering with the device or improper operation will lead to a loss
of warranty! If problems occur, ACD must be asked for their
decision in order to send in the device for repair at their premises.
ATTENTION
The power supply is electrically isolated from the device.
Bear in mind, however, that this electrical isolation ceases to be
effective if the interfaces (COM/USB) of the device are directly
supplied with input voltage (without electrical isolation).
ATTENTION
This can lead to the destruction of components of the device.
The device may only be opened by trained specialists, and only
after consulting with ACD.
ATTENTION
The MFT10 is equipped with a rechargeable lithium ion battery
pack. Lithium ion battery packs can explode if exposed to fire. The
battery pack must not be disassembled and exposed to fire or heat
(greater than 60 °C (140 °F). The battery must not be charged
externally via an external charger, but only via the table power
adapter provided by ACD or the vehicle's power supply. Since the
battery pack is plugged inside the terminal (no spare battery), the
ATTENTION
battery pack may only be changed by ACD or by ACD trained
service staff. Devices or battery packs which are no longer used
must be disposed of as toxic waste or returned to ACD (WEEE
directive).
Prior to each use, the terminal as well as the connection cables
must be inspected for damage. Damaged parts must be replaced.
Please contact ACD in this case.
ATTENTION
Prior to each journey, the mounting bracket of the MFT10 must be
inspected for damage (tear, deformation). Defective mounting
brackets must be replaced for your own safety.
ATTENTION
In order to prevent excessive heat, the terminal, as well as the
power pack (if a power pack is used), must not be covered while in
use.
ATTENTION
Do not place the terminal close to any heat sources (such as space
heaters) and do not expose it to direct sunlight or excessive dust
sources.
ATTENTION
Make sure there is no risk of stumbling over connection cables or
power packs.
ATTENTION
MFT10_Brief Overview_Resumen_breve_FCC_V1.00_en_es
5 / 40

Publicidad

Tabla de contenido
loading

Productos relacionados para ACD MFT10

Tabla de contenido