Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6.2
Before use
•
Before use, always check the State Of Charge of the battery pack. See section 3.5.
6.3
During use
6.3.1
Changing the battery pack
The battery pack has a LED indicator that indicates the approximate battery level (the State Of Charge).
No lit LED indication will be shown during the operation of the tool.
CAUTION
•
Many cycles in a short time may cause temperature increase above allowed limits. The
battery protection will shut down the battery until the temperature lowers to a value within
allowed limits.
•
Using the battery pack at temperatures above 45 °C (113 °F) reduces the life time of the
battery pack.
Refer to Fig. 6.
•
Switch off the tool using the on/off switch.
•
Remove the battery pack.
•
Place a new battery pack on the tool.
•
Switch on the tool using the on/off switch.
NOTICE
It is highly recommended to have at least one fully charged spare battery pack available at
all times.
NOTICE
To protect the battery pack, the tool will stop as soon as the battery pack gets empty. It might
happen that at that time the tool is fixated. To remove the tool it is best to replace the battery
pack by a fully charged one. When this is not possible the battery pack can be activated
again by pushing the SOC indicator button. To prevent damaging the battery pack, this can
only be done a limited number of times.
6.3.2
General
The plungers open and close quickly until they encounter resistance. Now the pump will build up the
required pressure and continue with spreading, pulling or crushing.
DANGER
Danger of crushing or pinching parts of the body. Note that hydraulic tools have an enormous
power, use only genuine Holmatro accessories and no other fasteners or chains
44
916.400.015_006
GTR 53* (LP) EVO 3
Publicidad
