Remove The Cover - General Electric GLE12HSLSS Manual Del Propietario E Instrucciones De Instalación

Accessory Installation Instructions
WATER VALVE ASSEMBLY

REMOVE THE COVER

Remove the
compressor
compartment access
cover. This requires
removing Phillips
head screws which
attach the cover to the back of the refrigerator case.
Be sure to save the screws as the access cover must
be reinstalled later to ensure your refrigerator will
function properly.
49-60769
ATTACH THE WATER VALVE
● U se pre-installed water tube to connect to water
valve. Do not use the water tube that came with
the water valve. To remove the water tube from the
water valve, push the white washer towards the
water valve and pull out the water tube.
● P ull out the black water tube from right side of
machine compartment. Remove the tape from the
end or if you can not remove the tape completely,
cut the end at 0.5". Make sure that you cut it
straight. Make a mark at 0.5" from the cut end.
Insert the water tube to the water valve all the way
to the mark 0.5" from the end. Loop and tuck the
rest of tube back to compartment.
● L ocate the female
connector plug.
Plug the female
connector onto the
male terminals on the
water valve. Either
wire can go on either
terminal.
● F asten the water
valve to the cabinet
by driving one of
access cover screw
into the hole in the
cabinet leg.
21