How To Use - Black and Decker VC3000 Manual Del Usario

VC3000Pub1000001155RV2 6/20/05
C
† 1. 1.5L plastic dust collector (Part# VC3000-09)
† 2. Dust collector cover/HEPA filter holder
3. Dust collector handle/Carry handle
† 4. HEPA filter (Part# VC3000-02)
† 5. HEPA filter screen
(Part# VC3000-01)
† Consumer replaceable
2:16 PM Page 16
(Part# VC3000-08)
15
ASSEMBLING/DISASSEMBLING YOUR VACUUM CLEANER
Flexible Swivel Hose
1. To connect hose, push connector end into the opening
on the front of the vacuum canister until it clicks into
place (D).
D
2.To remove, press the release button on the hose connector
and pull out (E).
E
Extension Telescopic Tube
1.To connect extension telescopic tube to sweeper, push thin
end of tube into sweeper (F).
Tip: Rotate the tube until the accessory holder clip faces
the back side of the tube. This will make it easier to store
the unit.
F
2. To connect tube to flexible hose, fit the thin end of the hose into the other end of
the tube. You might have to twist the tube slightly for a firm fit.
3. To remove extension telescopic tube, just pull out either end.

How to Use

This appliance is intended for household use. It is for indoor use only.
Important: For warranty verification, do not remove line cord sticker.
120 V Models Only - Your unit has a motor overheating protection system that
automatically shuts off the motor.
Important: The power cord has a yellow marking and a red
marking to help you determine the maximum length to use.
Up to the yellow mark is the recommended length. Never
pull cord beyond the red marking.
1. Holding the power cord by the plug, pull out the required
length and plug into a standard electric outlet (G).
G
2. With your foot or hand, press the on push button to start
the vacuum cleaner (H).
H
16