Blue Clean AR 112 S Instrucciones De Montaje, Cuidado Y Uso página 7

ASSEMBLY INSTRUCTIONS
3
Slide cord hook holster (D) onto right side, when facing
power washer unit (C) as shown.
Note: This step does not require any screws.
5
F
E
Connect the other end of Soft PVC high pressure
hose (E) to spray gun (F) by inserting the silver metal
ahead of trigger guard. It will lock into spray gun with
slightly pulling on hose. The hose is now securely at-
tached to spray gun.
Note: DO NOT press button on underside of gun when
connecting hose to gun.
92723_15ANR009 AR112S_1500PSI ENG-FR-SP.indd 7
D
OFF/O C
ON/I
C
4
Soft PVC High Pressure Hose Assembly
Screw Soft PVC high pressure hose (E) clockwise onto
bottom front of power washer unit (C). Pull back collar
and insert o-ring post into water outlet far enough so
collar can thread onto outlet threads until hand tight.
If it takes fewer than six turns you have not properly
easier to position the power washer in front of you to
ensure that the threads are started correctly. Failure
to properly tighten Soft PVC high pressure hose will
result in the hose slipping or popping off immediately
upon turning unit on. Do not worry about damage if this
occurs–just reinstall and take extra care when screwing
Note: DO NOT use pliers or locking pliers to tighten.
6
F
E
2
To release hose (E) from spray gun (F), press button on
underside of gun toward trigger guard. The hose will
slide out from connection.
C
E
7
2018/3/6 下午2:03