Publicidad
Terminator
1.
Slide appropriate IEK insulation entry kit
components onto cable. (Order Separately)
3.
Mount expediter to bracket using M5 x 8 mm
screws and M5 lock washers.
6.
Insert cable into expeditor. Make sure bus
connection (HPT and FP only) remains
outside of expediter.
ZT-P-WP
TM
2a.
Mounting Method 1: Secure wall mount
bracket to mounting surface using pipe band
provided with kits.
4.
Locate bus connection (HPT and FP only)
as shown. Cut end of cable at angle to aid in
piercing grommet. Leave additional cable for
expansion as needed.
7.
Cut off end of cable.
INSTALLATION PROCEDURES
2b.
5.
8.
3
Mounting Method 2: Secure wall mount
bracket to mounting surface using customer
supplied screws, fl at washers, and nuts.
GRW
GRW-G/Tstat
For HPT and FP cable, exchange grommet in
Terminator with grommet provided in PETK-3-ZT.
Terminate cable with appropriate PETK
termination kit. Refer to PETK installation
instructions. Push excess cable back through
expediter. Tighten cap securely. Tape cable
expansion loop to pipe.
Publicidad
