Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Battery Installation and Replacement
The remote control is powered by two 15V AAA batteries.
To install or replace batteries:
1.
Install/Replace the batteries by removing the battery
cover and sliding in two new "AAA" batteries.
Important: Match the batteries to the (+)
and (-) marks on the inside of the remote control.
2.
Snap the battery cover back onto the remote control.
CAUTION
Incorrect usage of batteries can result in leaks or
bursting. Peerless-AV recommends the following
battery use:
1.
Do NOT mix battery brands.
2.
Do NOT combine new and old batteries. This can
shorten the battery life or cause liquid leakage of
the batteries.
3.
Remove dead batteries immediately to prevent
battery acid from leaking into the battery
compartment.
4.
Do NOT touch exposed battery acid as it may
injure skin.
5.
Remove the batteries if you do not intend to use
the remote control for a long period of time.
Cable Management and Soundbar Orientation
For Digital Connection:
1.
Connect the provided toslink cable to the optical
digital audio out port on the TV. Make sure the cable
is fully inserted.
2.
Plug the other end of the optical cable into the
optical port on the soundbar. Make sure that there
are no excessive bends or pinch points when
connecting the optical cable.
3.
Plug the soundbar's power cable into the nearest
outlet.
4.
Note: When optical digital audio port is not being
used on the soundbar the port cover should remain
closed
For Analog Connection:
1.
Connect the soundbar's 3.5mm audio cable to the
audio out port on the TV. Make sure the 3.5mm
audio cable is fully inserted.
2.
Plug the soundbar's power cable into the nearest
outlet.
3.
Note: If the audio output of the TV is RCA stereo, a
female 3.5mm to male RCA stereo audio cable will
be required.
Female 3.5mm to male RCA stereo
audio cable (sold seperately)
19
2017-07-25
#:180-9109-2
(2017-08-28)
Publicidad
Tabla de contenido
