JVC VN-C215V4U Guía De Inicio página 11

Camera unit/Inside the camera
T This is when the dome cover, inner cover and outer case is removed.
How to remove ( A Pg. 17 AMounting on a ceilingB Steps 3. to 5.)
Lens section
(A Pg. 13)
J
K
L
M
N
H
Power supply/Alarm signal cable
(A Pg. 24, 26)
Signal name
Alarm input 1
Alarm input 2
Alarm output 1
Alarm output 2
GND
DC 12 V power supply+
DC 12 V power supply-
Note :
● Do not use PoE together with DC 12 V power
supply. Simultaneous connection will cause
failure or malfunction.
I
[10BASE-T/100BASE-TX(PoE)] Connector
for LAN cable connection (RJ-45)
(A Pg. 26)
J
Strap
This sheet connects the camera unit to the dome
cover.
W
V
U
T
S
R
Q
P
K
This is the screw head of the ceiling mounting
bracket Q, which is used to embed the camera
Cable color in the ceiling.
Pink
L
This is a button for rebooting the camera. Press
Blue
this button and release within 5 seconds to
Orange
reboot the camera. It takes about 1 minute for
Yellow the camera to reboot. During startup, [RESET]
button is disabled.
Brown
Note :
Red
● Pressing the [RESET] button for 5 seconds
Black
M
(A Pg. 27)
N
O
P
mounting screw
Connect the camera unit N and the outer case C
with the fall-prevention wire fastening screw O.
Behind the camera unit
O
Fastening screw (x3)
[RESET] Reset button
or longer switches the camera to the service
verification mode. Do not press the button for
5 seconds or longer.
[MONITOR] Monitor terminal (RCA pin)
Camera unit
Fall-prevention wire fastening hook
Fall-prevention wire (supplied) and wire
P
Y
MAC address
X
E-11