Mounting The Camera Directly On A Ceiling Or Alongside A Wall - JVC VN-C215V4U Guía De Inicio

Setup
Mounting the Camera
(continued)
Mounting the camera directly on a
ceiling or alongside a wall
To mount on a wall, use the same procedures
below but replace the word "ceiling" with "wall".
Setup
1.
Open a hole in the ceiling (R35 mm,1-3/8
inches)
Use the attached template to drill a hole in the
ceiling.
2.
Draw the fall-prevention wire, LAN cable,
power cable and alarm cable from the ceiling.
These are mounted beforehand on the
ceiling slab. (The fall-prevention wire is not
supplied)
Note :
● Also pay careful attention to the length,
strength, wiring and material (insulation
quality) of the fall-prevention wire to be used.
● For the fall-prevention wire, the inside
diameter of the ring section to be mounted on
the camera unit should be between R3.1 mm
and R5.5 mm, and the outside diameter
should be below R9 mm.
(1-3/8 inches)
1
Fall-prevention wire
(not supplied)
Power cable,
alarm cable
LAN cable
3.
Remove the dome cover.
As shown in the picture, hold the dome ring such
that the position alignment mark is between your
thumb and index finger. Turn the dome ring in
the anti-clockwise direction and remove.
Dome ring
4.
Remove the inner dome.
The inner dome is secured by 3 clips. Remove
the inner dome from the clips.
E-20
R35 mm
2
Approx. 100 mm
(3-7/8 inches)
Position
alignment mark
5.
Remove the outer case.
A
Loosen the camera fastening screws with a
screwdriver.
B
Turn the camera in the anti-clockwise
direction and remove the outer case.
C
Remove the fall-prevention wire from the
fastening hook
6.
Loosen the pan fastening screw.
Note :
● The lens section may be damaged if you operate
it without loosening the pan fastening screw.
7.
Configure image settings. (A Pg. 13)
4
7
5
B
Connection
1.
Face the imaging direction mark (j) in the
shooting direction and mount the outer case
on the ceiling.
About the outer case mounting screws
(not supplied):
● Use a screw head of less than 3 mm.
● The mounting hole of the outer case is
R 4.5 mm.
● Do not use a flat countersunk head screw.
● When using an impact driver, do not
tighten right to the end. Tighten with your
hand. The outer case may be damaged.
2.
Hitch the fall-prevention wire that was
removed in Setup step 4. on the fastening
hook.
3.
Mount the fall-prevention wire on the
camera. This wire connects the camera to the
ceiling.
(The fall-prevention wire is not supplied.)
Note :
● Tighten all screws securely. Otherwise the
camera may come loose and fall.
Inner dome
5
A
6
Pan fastening screw
Camera Fastening
Screw
5
C