INSTALLATION INSTRUCTIONS
DANGER: Fixture must be connected to a 120 Volt, 60 Hz power
source.
DANGER: Turn power off at the circuit breaker or fuse box before
starting installation!
DANGER: DO NOT rely on wall switch alone to turn off power.
Step 1:
Attach Fixture Housing Assembly
Select a location on a flat wall with structurally sound wood and from 10 to 25 feet (3 to 7.6 m)
from the ground. The wood should be at least one inch (25 mm) thick to safely secure the fixture.
The fixture (A) can be mounted with three lag screws (AA) and washers (BB) which are provided.
Using the fixture (A) as a mounting template, mark three mounting holes. We suggest drilling
3/16 in. (4.8 mm) pilot holes for the lag screws. Install the bottom two (AA) with washers (BB)
first. Screw in the lag screws (AA) so that there is about 3/8 in. (9.5 mm) of space under (BB).
Place (A) on these two (AA) and install the top (AA) and (BB). Tighten the top (AA) first, and then
tighten the remaining (AA) (see Fig 1).
AA
AA
BB
BB
AA
BB
A
5
Lowes.com
ON
ON
OFF
ON
ON
ON
ON
ON
Fig. 1