Troubleshooting; Warranty - Utilitech 6240-PHO Manual Del Usuario

TROUBLESHOOTING

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
Problem
Light will not
come ON.
Light will not
come ON.
Light will not
come ON.
Light will not come
ON untill after
complete darkness.
Light will not turn
OFF untill full light.
Bulb flickers or will
not fully light.
TWO-YEAR LIMITED WARRANTY
If this product (excluding light bulbs) fails due to a defect in materials or workmanship during the term
of this warranty, the product will be replaced with the same or comparable model, or the purchase
price will be refunded or a store credit will be provided at the retail establishment where the product
was purchased at the option of the retail establishment or the manufacturer. For warranty claims
return this product to the retail establishment where the product was purchased or contact customer
assistance at the toll-free number: 1-866-994-4148, 8 a.m. - 6 p.m., EST, Monday - Thursday,
8 a.m. - 5 p.m., EST, Friday.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state. This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty
repair.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL OR
INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS PROD-
UCT. MAXIMUM LIABILITY SHALL NOT IN ANY CASE EXCEED THE PURCHASE PRICE OF THE
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION MAY NOT APPLY
TO YOU.
Possible Cause
No power to light.
Bulb burned out.
The photo control may catch other
light sources (such as car lights).
Photocell allowing too much light.
Photocell not allowing enough light.
Ballast failing.
Corrective Action
Check that the circuit is on, wall
switch is on, there is power to
light fixture.
Replace bulb with 100-watt
metal halide type M90/E bulb.
Check and reposition the installation
place to avoid other light source.
Then light will come on again.
Align photocell to North. Adjust
photocell to allow less light to
enter (see Fig. 5).
Align photocell to North. Adjust
photocell to allow less more to
enter (see Fig. 5).
Replace ballast. See Ballast
assembly replacement.
Utilitech & UT design® is a registered
trademark of LF, LLC. All Rights Reserved.
12
Lowes.com
Printed in China