Usage Of Detergent; Connection Requirements; Instructions For Use - Super Ego 200 Instrucciones De Uso Y Mantenimiento

The connection is opened by first pressing the
components together and then turning the pipe in an
anticlockwise direction.
Usage Of Detergente
This pressure washer is fixed with a detergent tank.
The capacity of this tank is about
1.28L
- To penetrate and remove the dirt more effectively
it is recommended to use the detergent dispensing
function.
- Spray the detergent on a dry surface,do not pre-sock
area.Wetting the surface first
dilutes the detergent and reduces its cleaning ability.
- For best results,limit your word area to smaller
sections of approximately 25seg.
- Allow wash to remain on the surface for 1-3
minutes.
- Rinse at high-pressure in a long sweeping motion
using a wide spray pattern..
- When moving on to a new section of the cleaning
surface,be sure to over tap the precious section to
eliminate marks.
Please note: Detergent is only applied at 69bar and
big volume of water flow.The detergent can only be
dispensed when the lance is set to low pressure by
organizing adjustment mechanism.
⇦
pull
high pressure
Connection Requirementss
Electrical connection
Only connect the machine to a properly installed
safety socket. Before inserting the mains lead into the
socket,check whether the voltage you intend to use
complies with that of the machine.
⇨
push
low pressure for detergent
Operating instructions
Extension Lead
Only extension leads that are protected against water
spray should be used with high mechanical strength
and an internal diameter of at least 3 x 1.5mm
Water Connection
The high-pressure cleaner is suitable for connection to
a standard domestic water supply. Please observe the
regulations of your water supply company.
The supply hose(not supplied)should have the
following dimensions:
Length: 7,5m
For the connection values please see the technical
data contained in these instructions.

Instructions for use

Use
- The device is intended for private use only.
- Clean machines, vehicles, buildings, tools, facades,
terraces, garden tools etc. with the high-pressure
water jet. If necessary you can use detergents.
- Please use detergents sparingly,.noting the quantities
recommended by the producer.
Please note
- The cleaning of motors/engines and other surfaces
that may be covered with oil is only allowed in
conjunction with an appropriate oil separator.
- Do not clean any surfaces that may contain
hazardous materials, such as asbestos.
Water
- If necessary, clean the supply water with a water
filter, Any impurities in the water could damage the
pump.
- Operating the high-pressure cleaner without water
will damage the pump.
- Please ensure before switching on the cleaner that
the water supply is available.
Cleaning Method
1. Spray the detergent sparingly on to the dry surface.
Allow it to act for a short time without letting the
detergent dry.
2. Rinse off the loosened dirt with the high-pressure
jet.
Water Loss
It is normal for the pump to lose small quantities of
water. If there is a sizeable leak, please contact our
service department.
11
Diameter: 1/2"
GB
.
2