GE 31-10251 Manual Del Usuario página 7

D. Turn the spring retainer over so that
L.P./Propane is showing on the bottom.
E. Snap the retainer back into position.
Fig. 11
NAT
NAT.
NAT
POSITION
4. Change the cooktop burner orifices:
A. Remove the top grates, burner caps and burner
heads.
Fig. 12
MIXER TUBE
BURNER
BOWL
B. Using a 7mm or 9/32" nut driver, remove the top
burner orifices. These may be accessed through
the burner air/gas mixer tube (chimney).
Fig. 13
NOTE: The orifices have a spring loaded
retaining ring around the hex head to
hold the orifice in the nut driver during
installation and removal.
amount of force is required to push
the nut driver down over the ring.
Fig. 14
GASKET
CAP
LP
SPRING
RETAINER
L.P.
LP
POSITION
PRESSURE REGULATOR
BURNER GRATE
BURNER CAP
BURNER HEAD
SPARK IGNITER
MIXER TUBE
(CHIMNEY)
MIXER TUBE (CHIMNEY)
A slight
RETAINER
RING
IMPORTANT:
future conversion back to natural gas.
5. Locate the L.P./Propane orifices.
The L.P./Propane orifices are shipped in the literature
package. They will have a digit number and the letter
"L" on one side.
Each orifice will also show a series of engraved
marks, (I, II or III), located on the top.
Fig. 15
These marks denote the precise location of each orifice
to the cooktop burner.
GLASS COOKTOP
Fig. 16
6. Install the L.P./Propane orifices in their precise
locations.
PROCELAIN COOKTOP
Fig. 17
Return the natural orifices to the bracket and re-attach
bracket and the instruction sheet to the pressure regu-
lator using the screw previously removed.
7
Save these orifices for