GE PGP976 Instrucciones De Instalación página 13

MAKING THE LP CONVERSION
3 CHANGE COOKTOP BURNER
ORIFICES
Remove the grates, burner caps, and burner
A
heads.
Using a 7mm nut driver, remove the burner
B
orifices. These may be accessed through the
burner holes in the cooktop.
Inner
burner cap
Burner
Outer
base
burner
cap
Electrode
Burner
base
Orifice spuds located
through these openings
Tri-Ring Burner
Retainer
Ring
Locate the LP/Propane orifices shipped inside
C
the literature package. They will have a digit
number and the letter "L" on the side.
(Important: Save the orifices removed from the
appliance for future use.)
Each orifice will show a series of engraved
marks, (I, II, III, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
I x1 II x2
For PGP976 Models
I x1 II
x2
For PGP986 & CGP650 Models
See instructions
for center burner
Installation Instructions
Burner
OR
Burner
head
Burner
base
Orifice spud located
Electrode
through this opening
NOTE: On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
III x1 IV x1
III x1 V x1 V
x3, Tall
(CONT.)
3 CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CENTER BURNER
17,000 BTU/hr Extra Large Burner (PGP976 Models)
cap
Extended spud for center
extra large burner
13
Burner
Cap
Set Screw
Choke
Burner
Head
Extended
Spud
Base
Orifice spud located
through this opening