GE Profile PSB9120WW Instrucciones De Instalación página 7

Hornos con velocidad de cocción/convección incoporada de 120v de
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT:
Always maintain 36-3/4" minimum height from the floor to the cutout in any single or
combined installation unless plastic trim is installed.
PREPARE THE OPENING (cont.)
Installation over another GE Appliances/
Monogram Built-In SpeedCook Oven:
30
25-1/4
17-1/2
17-1/2
• If you are mounting a GE Appliances
Appliances/Monogram Built-In SpeedCook
Oven over another, use the dimensions shown.
The middle rail separating the two openings
may need to be larger than the 2 minimum
shown.
Standard Installation Preparation
Construct
23-1/2
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
support weight
of oven and
contents.
2 Min.
(3 Recommended)
PREPARE THE OPENING (cont.)
Installation under a GE Appliances/
Monogram Microwave Oven and over a
Warming Drawer:
30
Per Microwave
Oven Requirement
17-1/2
Per Warming
Drawer
Requirement
NOTE: Additional clearances between the
cutouts may be required. Check to be sure
the oven supports above the Warming Drawer
location do not obstruct the required interior
depth and height. See Warming Drawer
installation instructions for details.
CAUTION
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of the oven and drawer, plus additional oven
loads.
7
Construct
solid bottom - Min.
23-1/2
3/8" plywood
supported
on all four sides.
Must be able to
support weight
25-1/4
of oven and
contents.
3.5 Min.
(4.5 Recommended)
2 Min.
(3 Recommended)
For personal safety, the

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido