I Ending The Cleaning Cycle - Zodiac TornaX Manual De Instalación Y De Uso

3.6 I Ending the cleaning cycle

• To avoid damaging the unit, use the cleaner's handle to raise the cleaner and remove it from
the pool. Do not pull on the fl oati ng cable.
• Take the appliance out of the water each ti me cleaning is complete.
• Do not leave the appliance to dry out in sunlight aft er use.
• Store all the elements away from sunlight, humidity and bad weather.
• Once the cycle is complete, the appliance stops and the LED on the control box switches off .
• To stop the appliance during cleaning, press
• Carefully pull on the fl oati ng cable to bring the robot to the edge of the pool.
• When the cleaner is within arm's reach, pick it up by the handle and lift it gently out of the pool so that the water it
contains drains into the pool (see image
• Place the cleaner on the ground or verti cally at the locati on provided on the caddy (available as an opti onal extra) for
it to dry out quickly. Then store it with the control box away from sunlight and any splashes.
Tip to prevent the fl oati ng cable from becoming tangled
The appliance's behaviour is strongly impacted by the tangling of the cable. A cable that is correctly untangled
will guarantee bett er coverage of the pool.
• Untangle the cable and lay it out in the sun so that it returns to its original shape.
• Then wind it up carefully and place it on the caddy handle (available as an opti onal extra) or on a fi xed
support.
9
; the LED goes out.
).