Sartorius YDP04IS-0CEUV Instrucciones De Instalación página 5

The normal operating mode for the YDP04IS-
0CE printer is the "Line Mode." If the printer
does not print, it may currently be in the "Page
Mode." To switch between the two modes, use
the "FEED" button.
To switch the operating mode:
§ Turn off the printer, press the "FEED" button;
turn the printer back on while holding down the
"FEED" button
§ Let go of the "FEED" button when the control
LED in the "FEED" button flashes in green
§ Wait until the control LED in the "FEED" button
goes out and then flashes in green again; then
immediately press the "FEED" button and hold
it down
§ Wait until the control LED in the "FEED" button
lights up in amber (orange); then immediately
let go of the "FEED" button
§ Wait until the control LED in the "FEED" button
lights up in green
> The printer is now switched to another mode.
Note:
Let go of the button immediately
control LED in the "FEED" button lights up in
amber (orange). If it is held down too long, the
printer may switch to the "Download" operating
status. The printer can only be changed from
this status by downloading firmware. In this
case, please contact our service department.
immediately when the immediately immediately immediately
5