Carton Contents; Install Wheel Kit - Generac Portable Products Power Boss 4500 Contractor Manual Del Propietário

ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408.
Remove Generator From Carton
• Set the carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
• Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping carton.
Figure 1 — Install Wheel Kit
Support Leg
Vibration Mount
PowerBoss 4,500 Watt Contractor Generator
Hex Nut
30mm Cap Screw

Carton Contents

Check all contents. If any parts are missing or damaged, call
the generator helpline at 1-800-270-1408.
• The generator
• Generator and engine owner's manuals
• Locking 30 Amp plug
• Engine oil
• Wheel kit

Install Wheel Kit

The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a socket wrench with 1/2" or 13mm sockets
and a needle-nose pliers to install this kit.
Refer to Figure 1 and install the wheel kit as follows:
1. Place the generator on a hard flat surface.
2. Stand at the engine end of the generator and gently tilt
the generator forward, high enough to place wooden
blocks beneath the cradle.This will allow you to add
the wheels.
Wheel
Axle
20mm
Cap Screw
Flat Washer
Hex Nut
5
E-Ring