Sharpening Slotted Screwdrivers; After Sharpening - Kitchen Living GT-AS-01-US Manual Del Usuario

Knife
Electric Sharpener

Sharpening slotted screwdrivers

You cannot grind Phillip's head screwdrivers or similar with
this sharpener. You can only sharpen slotted screwdrivers.
1. Applying only slight pressure, run the screwdriver into the sharpening
1
slots from the top so that it is centric with the grindstone (see Fig. D).
2. Take the screwdriver out and check the edge condition. If necessary, correct
the edge condition if only one side has been sharpened.
3. Turn the screwdriver over or use the second sharpening slot
the other side.
4. You can use the coarse sharpening slots
the screwdriver is very dull or already has notches. You can make slight cor-
rections to the edge condition with the two fine sharpening slots.
5. Then slowly and carefully run the screwdriver into the grinding opening for
5
screwdrivers in a level position to grind the tip straight.

After sharpening

1. Turn the sharpener
2. Pull the power plug.
3. Push the wind-up button for the power cable
drawn into the housing sing g
4. With the sharpener in one hand, tap it with your other hand so that any resi- ner in one ha r in one
due falls out of the sharpening slots. of the sharpe the sharpe
5. Wipe the sharpener and the work surface off with a damp cloth. sharpener an harpener a
AFTER SALES SUPPORT
USA
1 866 558 8096
10
fine sharpen fine sharpen
ver into th ver into t
grind t ind
9
off with the ON/OFF switch. th the ON/O the ON/O
ton for the p n for the
8 8
. . .
Operation
2
to grind
11 11
and in the s in the sa in the same manner if
hes. You can hes. You can
e tip
4
– the power cord will be
service@801service.net
USA
p
15