Technical Data; Pneumatic Connections - Michelin MBL 6 Manual De Uso Y Mantenimiento

EN
- Be very careful when using the compressor, as some of its parts such
as the head and delivery pipes can get extremely hot. Do not touch
these parts to avoid getting scalded.
- Use the dedicated handles or grips to lift the compressor to move it
around.
- If you use the compressor for painting:
a) Do not use it indoors or near naked flames.
b) Make sure that the area in which you work has a sufficient change
of air.
c) Protect your nose and mouth by wearing a dedicated mask.
- When you have finished using the compressor always remember to
switch it OFF and unplug it from the mains.

TECHNICAL DATA

Maximum running pressure: 6.7 bar
Maximum working pressure: 6.5 bar
HP / W
0,4 / 300
The sound pressure level measured in a free range at a distance of 4
mt. at the maximum working pressure.The value of the sound level
may increase from 1 to 10 dB(A) depending on the environment in
which the compressor is installed.
HINTS FOR EFFICIENT OPERATION. This compressor has been
designed for DIY use with intermittent (not continuous) operation. The
use of the compressor for more than 20 min. during one hour is not
recommended.

PNEUMATIC CONNECTIONS

Make sure that pneumatic tools for compressed air with maximum
pressure characteristics that are adequate for the compressor are
used. Do not attempt to repair faulty tubes.
USE WITH TOOLS
WARNING! Always disconnect the air tool from the air compressor
before changing tools, accessories, servicing and during non-
operation.
IMPORTANT: When securing wheel nuts it is important to set the
regulator to the minimum setting, then use a torque wrench to set
fastener torque. Wheel nuts must be tightened to the vehicle
manufacturer's recommendation.
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT
ANY PRIOR WARNING WHERE NECESSARY.
RPM DB(A)
4600 80
8