Oil And Petrol; Gear - Texas Hobby 500 B Manual De Instrucciones

3. Figure 3.
Mount the two lower handlebars with the bolts supplied (c,d). Note that the left and
right handlebars are different.
Steer (a.) must be mounted on the right. Steer (b.) must be mounted on the left.
4. Figure 4,5.
Mount upper handlebar using the bolts supplied and the hand wheel
Note the arrows on the plastic brackets. They must be aligned when mounting.
5. Figure 6, 7, 8
Mount throttle cable (a.) and clutch cables (b.) as shown on the picture.
6. Figure 10
Mount the blades using the cotter bolts and pins.
It is important that the edge of the blade faces forward as shown in figure 22.
7. Figure 11.
Mount the side guards using the bolts and nuts supplied
8. Figure 12.
Mount bracket for starter handle, as shown on the picture.
Operate the clutch handle on the right, and pull the starter handle. Attach the
line/handle in the bracket.
9. Figure 13.
Mount depth skid with the cotter pin supplied.

Oil and petrol

Note – Oil and petrol are not included!
Oil and petrol are not supplied with the machine. Fill the engine with 0.6 litres of SAE 30
engine oil and octane 92 or 95 unleaded petrol.
For further information about the engine, see the attached engine manual.

Gear

The gear shall be filled with 60 ml grease for every fifth operation hour.
Maintenance
Add grease until it runs out of the filler hole when the machine is horizontal.
Remove the spark plug cover on the engine.
-
Add grease to the gear.
-
Place the pack of grease in a bucket of warm water. This will make the consistency
12