Fuel Filter - DeVillbiss PowerBack GM1000 Manual Del Operador

4. Unscrew and remove the fuel valve
bowl.
Fuel
Valve
Bowl
5. Clean and replace fuel valve bowl.
Tighten securely.
6. Replace and secure panel.

Fuel Filter

NOTE: It is recommended to run all the
gasoline from the tank before changing
or cleaning the fuel filter.
1. Stop engine as described in the
Operation section.
2. Place the fuel valve lever in the OFF
position.
3. Remove the recoil end panel as
described in the Fuel Valve Bowl
paragraph.
4. The fuel line can be removed from
the fuel filter cover by squeezing the
fuel clamp and sliding it up the fuel
line.
Cap
Fuel Clamp
Fuel Line
5. After removing the fuel line unscrew
the cap on the fuel filter cover.
NOTE: Do not loose rubber washer
from fuel filter cover cap.
A04669
Fuel Valve
Fuel Filter
Cover
6. The fuel filter can now be removed
to clean or replace.
7. Place new or cleaned filter into
cover.
8. Press rubber washer into fuel filter
cap and screw cap into fuel filter
cover body.
9. Reconnect fuel line.
10. Replace and secure panel.
Fuel Tank Filter
Cleaning
1. Stop engine as described in the
Operation section.
2. Remove gas cap and remove the
fuel tank filter.
3. Clean with solvent. Wipe off excess
solvent and replace fuel tank filter
into tank.
4. Replace gas cap.
Muffler Screen
Cleaning
1. Stop engine as described in the
Operation section.
2. On the exhaust end of the unit,
remove the four screws securing
the sides of the panel and the two
fasteners with isolators securing the
bottom of the panel. Carefully pull
panel away from the unit noting the
insulation is attached to the panel.
16- ENG