Safety Instructions; Electrical Safety - Build Worker BTC600-180 Manual Del Usuario

TILE CUTTER
WARNING
Read this manual carefully before using the
machine, for your own safety.

SAFETY INSTRUCTIONS

When using the machine, always observe the
enclosed safety instructions as well as the
additional safety instructions.
The following symbols are used throughout this
manual:
You will find the following symbols on the
machine:
ADDITIONAL SAFETY INSTRUCTIONS FOR
TILE CUTTERS
Make sure that the cutting disc is correctly
screened by the guard.
Never remove the riving knife. The distance
between the cutting disc and the riving knife
should not exceed 5 mm.
Do not use cutting discs which are bent,
deformed or otherwise damaged.
Do not use cutting discs which do not comply
with the specifications stated in this manual.
Never start cutting tiles before the machine
reaches full speed.
- GB -
Denotes risk of
personal injury or
damage to the tool.
Take measures to
protect your eyes.
Take measures to
protect hearing.
Do not use toothed
cutting discs.
After having used
the machine
continuously for 20
minutes, let it cool
down to ambient
temperature.
Consult the manual.
Never attempt to cut extremely small
workpieces.
Do not leave the work area until the machine
has been switched off and the cutting disc has
come to a complete standstill.
Never attempt to stop the cutting disc by
exerting pressure on the side of the disc.
Always unplug the machine before performing
any maintenance.
Do not use the machine before it has been
completely assembled and installed according to
the instructions.
Do not perform any design, assembly or
construction activities on the table while the
machine is switched on.
Unplug the machine and clean the table
before leaving the work area.

ELECTRICAL SAFETY

DESCRIPTION
Your tile cutter has been designed for cutting
ceramic and clay paving and wall tiles.
1 On/off switch
2 Mounting hole
3 Cooling water reservoir
4 Table top
5 Safety guard
6 Riving knife
7 Cutting disc
8 Parallel guide
MOUNTING THE MACHINE
The machine must be screwed to a workbench.
Mark the position of the mounting holes (2) on
the workbench.
Drill holes at each of the marked positions,
adjusting the diameter and depth of the holes to
the screws used.
Place the machine on the workbench and
insert the screws into the mounting holes.
Firmly tighten the screws.
MOUNTING THE GUARD
Fit the riving knife (6) to the table (4) using the
screws.
Place the guard over the riving knife (6).
Fit the guard (5) to the riving knife. Tighten the
lock knob.
8
Always check that
the power supply
corresponds to
the voltage on the
rating plate.
Never cut tiles
without having the
guard in place.