Attaching Or Removing A Stand; Removing The Handle - Saltillo TouchChat Express-D Guía De Uso

Attaching or Removing a Stand

Two stands—a long stand and a short stand—were provided with your TouchChat Express. The amplifier
itself provides a bit of an angle for viewing the screen when sitting on a flat surface. If an additional
angle is needed, attach one of the stands to the back of the amplifier.
The stands were designed to be break-away to avoid pinching. Either stand is secured to the amplifier
handle with a tension fit.
To attach a stand: Spread the legs of the stand apart, position the stand over the amplifier, and insert
one leg, then the other in the holes at the base of the amplifier's handle.
To remove a stand: Spread the sides of the stand and pull the legs out of the holes at the base of the
handle.
Stand
Screw for
securing
the handle

Removing the Handle

To remove the handle from the amplifier:
1. Remove the stand, if it is in place.
2. Remove the screw from each side.
3. With some tension, extend the sides out around the case.
The stand and screws from the handle are potential choking hazards.
TouchChat Express User's Guide
Hole at base of handle
for mounting the stand
61