Maintenance And Cleaning - Kinderkraft KOYA Manual De Usuario

the legs with four screws (1) (Figure A). Repeat this step with the other legs and the other
headboard.
2. Place the side (9) and the side extension (10) on a soft surface so as not to damage the
components. The five holes in the both components should be parallel. Note that both
components should have the same designation: either A or B. Slide three connectors (3) into
the holes in the side extension (10). Then insert the three screws (1) through the side (9) and
screw together the two components (Fig. G). Repeat these steps when connecting the other
two components (9 & 10).
3. Position one of the sides of the playpen perpendicularly to one of the structures assembled in
step 1. Make sure that the ten holes in the sides are facing inwards. Make sure that the wider,
horizontal side slat (9) and side extensions (10) are facing down. Screw the side to the structure
using two screws (1) (Fig. B). Using two screws (1), connect the side to the second headboard.
4. Attach the other side. Make sure that the ten holes of the side panel are pointing inwards. Make
sure that the wider, horizontal side slat (9) and side extensions (10) are facing the bottom. Screw
the side to the structure using four screws (1).
5. Place the bottom (11) and the bottom extension (12) with rungs upwards on a soft surface so
as not to damage the components. Note that there are four holes in one of the shorter bottom
slats and the bottom extensions that need to be put together. Slide the four connectors (3) into
the holes in the bottom extension (12). Then put the four screws (2) through the bottom (11)
and connect the two pieces (fig. H).
6. Screw the playpen bottom extension to the structure from step 4 with eight screws (2), making
sure that the mounting holes in the bottom are on the underside. Make sure that the bottom
extension (12) is on the same side as the side extensions (10). Attention! The playpen bottom
can only be adjusted to the lowest level (fig. M - V).
7. Mounting the wheels: Screw the wheels (6) to the structure (fig. F) using the spanner (4). The
wheels have a locking device which must be engaged when the playpen is set up in the desired
position. To engage the lock, move the lever downwards (fig. I).
8. Make sure that all connections are securely tightened. The playpen that is ready to use is shown
in figure W.
VI MAINTENANCE AND CLEANING
Frame - clean with a soft, clean and dry cloth. Clean the mattress cover according to the instructions
on the label.
Handwash.
Do not bleach
Do not dry in a tumble dryer
Do not wash. Clean the product
gently with a damp cloth and a mild
detergent.
Do not iron
Do not dry clean
39