Service Information; Full Two-Year Home Use Warranty - Black and Decker Fire Storm FSNS100 Manual De Instrucciones

639224-00 FSNS100 Stapl
Disconnect tool from air supply before performing any Service
Procedure.
SYMPTOM
1. Air leak near top of
tool or in trigger area. Worn or damaged
2. Tool does nothing or
operates sluggishly.
3. Air leak near bottom
of tool.
4. Tool jams frequently.
5. Other.
ACCESSORIES
Recommended accessories for use with your tool are available from your local retailer
The use of any accessory not recommended for use with this tool could
be hazardous.

SERVICE INFORMATION

Black & Decker offers a full network of company-owned and authorized service
locations throughout North America. All Black & Decker Service Centers are staffed
with trained personnel to provide customers with efficient and reliable power tool
service.
Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you.
To find your local service location, refer to the yellow page directory under "Tools—
Electric" or call: 1-800-544-6986.

FULL TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship. The defective product will be replaced or repaired at no
charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns
should be made within the time period of the retailer's policy for exchanges (usually 30
to 90 days after the sale). Proof of purchase may be required. Please check with the
retailer for their specific return policy regarding returns that are beyond the time set for
exchanges.
12/14/05 7:26 AM Page 11
TROUBLESHOOTING
PROBLEMS SOLUTIONS
Loose screws. Tighten screws.
B&D service for overhaul.
o-rings or seals.
Inadequate air supply. Verify adequate air supply.
Inadequate lubrication. Put 5 or 6 drops of oil into air inlet.
Worn or damaged B&D service for overhaul.
o-rings or seals.
Loose screws. Tighten screws.
Worn or damaged B&D service for overhaul.
o-rings or bumper.
Incorrect fasteners. Verify approved fasteners of
correct size.
Damaged fasteners. Replace w/undamaged fasteners.
Magazine or nose Tighten screws.
screws loose.
Magazine is dirty. Clean magazine.
Driver is worn or damaged. B&D service for driver maintenance.
Contact a Black & Decker
Service Facility.
11
.